How to maintain your laser machine in winter

Godworker laser machines startup precautions in winter (water cooling)

1: Ensure that the indoor temperature is between 5-35℃ before the laser machine can be turned on and used.

2: Check whether the water cooling pipe is frozen. If it is frozen, the laser machine cannot be turned on.

3: If there is ice formation, please turn on the air conditioning or heating facilities, adjust the ambient temperature of the laser machine to be 5-35℃, and stewing for more than 4 hours. Only can do the next operation after the ice naturally melts. Do not use violent deicing to avoid damaging the equipment hardware.

4: After confirming that the laser machine isn't frozen, it is necessary to first turn on the chiller for preheating.

5: Wait until the circulating temperature of the chiller reaches normal temperature (recommended temperature: around 25 ± 1℃) before turning on the laser.

6: After starting up normally, adjust the energy to below 30%, preheat the idle light for about 10 minutes, and then proceed with normal production operations.

Godworker laser machines antifreeze maintenance measures in winter (air-cooled).

1: The air-cooled laser machine doesn't require the addition of antifreeze or equipment drainage operations.

2: Install air conditioning or heating facilities to maintain the operating environment temperature of the equipment above 5℃.

3: After starting up normally, adjust the energy to below 30% and keep the other parameters unchanged (the operation interface is shown in the figure below). Preheat the empty light for about 10 minutes before proceeding with production processing.

4: When laser equipment is not in use for a long time or in a power outage state, it is necessary to store it in a dry place above 5℃.